Messages · Step
HTTP request
Call a web address and use its answer.
http_request
In a flow
“When a button is clicked, HTTP request.”
What it does
Call a web address and use its answer. It's a step: it runs when the white wire reaches it, then the flow carries on from its Then pin. It gives 1 value later steps can use. Find it under Messages in the palette.
When to use it
Use it when the flow needs to call a web address and use its answer.
When not to
If nothing should change in Discord, a value node or a check is lighter.
Typical wiring
Sockets: settings you can wire
- Address Text needed
-
Starts with https://. Variables allowed.
What goes there: Type it in the side panel, or wire in text. e.g. Hello there
If it's empty: Needed. Publish lists it until it's set or wired; the step can't run without it.
Connects fromA member's variablesAccept applicationAdd a Notion pageAdd a Trello cardAdd an emojiAdd to number in objectAdd up timesAdd working daysand 844 more
- Body Text
-
What to send. Variables allowed.
What goes there: Type it in the side panel, or wire in text. e.g. Hello there
If it's empty: Optional. Left empty and unwired, the step runs without it.
Connects fromA member's variablesAccept applicationAdd a Notion pageAdd a Trello cardAdd an emojiAdd to number in objectAdd up timesAdd working daysand 844 more
Values it gives
- Status Number
-
A number this step gives the steps after it. e.g. 42
If it's empty: Empty when the step didn't make one (it stopped early or was skipped); steps reading it get nothing.
Connects toAccount ageActive membersAddAdd answer to formAdd soundboard soundAdd timeAdd to a counterAdd to a leaderboardand 718 more