Members & roles · Step
Disconnect everyone
Take everyone out of a voice channel, like when an event ends.
voice.disconnect_all
In a flow
“When a button is clicked, disconnect everyone.”
/end-event → Disconnect everyone from 🔊 Event.
What it does
Take everyone out of a voice channel, like when an event ends. It's a step: it runs when the white wire reaches it, then the flow carries on from its Then pin. It gives 1 value later steps can use. Find it under Members & roles in the palette.
When to use it
Use it when the flow acts on a member: take everyone out of a voice channel, like when an event ends.
When not to
If nothing should change in Discord, a value node or a check is lighter.
Typical wiring
Sockets: settings you can wire
- Voice channel Channel
-
The voice channel. Empty is the one the member is in.
What goes there: Type it in the side panel, or wire in a channel. e.g. #general
If it's empty: Optional. Left empty and unwired, the step runs without it.
Connects fromArchive channelAsk a questionCopy channelCopy permissionsCreate categoryCreate channelCreate forum postCreate threadand 60 more
Values it gives
- Disconnected Number
-
How many. e.g. 12
If it's empty: Empty when the step didn't make one (it stopped early or was skipped); steps reading it get nothing.
Connects toAccount ageActive membersAddAdd answer to formAdd soundboard soundAdd timeAdd to a counterAdd to a leaderboardand 719 more