Messages · Step
Switch
Run the output whose case matches a value, or Default.
switch
In a flow
“When a button is clicked, switch.”
What it does
Run the output whose case matches a value, or Default. It's a step: it runs when the white wire reaches it, then the flow carries on from its Then pin. Find it under Messages in the palette.
When to use it
Use it when the flow needs to run the output whose case matches a value, or Default.
When not to
If nothing should change in Discord, a value node or a check is lighter.
Typical wiring
Sockets: settings you can wire
- Value Text needed
-
Takes text.
What goes there: Type it in the side panel, or wire in text. e.g. Hello there
If it's empty: Needed. Publish lists it until it's set or wired; the step can't run without it.
Connects fromA member's variablesAccept applicationAdd a Notion pageAdd a Trello cardAdd an emojiAdd to number in objectAdd up timesAdd working daysand 845 more