Channels · Step
Remove from thread
Take a member, or everyone with a role, out of a thread. Reverse takes out everyone else.
thread.remove_member
In a flow
“When a button is clicked, remove from thread.”
Take @Trainee out of the planning thread.
What it does
Take a member, or everyone with a role, out of a thread. Reverse takes out everyone else. It's a step: it runs when the white wire reaches it, then the flow carries on from its Then pin. Find it under Channels in the palette.
When to use it
Take someone out of a thread, or with Reverse everyone except them. The opener stays unless you turn that off.
When not to
With Who empty it takes out the person who clicked. For a Claim button use Add to thread with Reverse instead.
Typical wiring
Sockets: settings you can wire
- Thread Channel
-
The thread. Leave empty for here: where this happened, or the new place in an "In the new …" branch.
What goes there: Type it in the side panel, or wire in a channel. e.g. #general
If it's empty: Optional. Left empty and unwired, the step runs without it.
Connects fromArchive channelAsk a questionCopy channelCopy permissionsCreate categoryCreate channelCreate forum postCreate threadand 60 more
- Who Member
-
Leave unwired for the member who started the flow, or wire one in, like Member from Find member.
What goes there: Type it in the side panel, or wire in a member. e.g. @Alex
If it's empty: Optional. Left empty and unwired, the step runs without it.
Connects fromAccept applicationApplication infoAsk a questionAsk follow-upBoard as emojiCall the next in the queueCase createdCheck for a lineand 87 more