World & blocks · Step
Set bell block attachment
Changes the bell block's attachment to one of the attachment values you pick. Paper: the value of the 'attachment' property.
m.bdata.bell.set_attachment
In a flow
“When a player right-clicks → Set bell block attachment: ceiling → Answer Done!”
When a player right-clicks → Set bell block attachment: ceiling → Answer Done!
What it does
Changes the bell block's attachment to one of the attachment values you pick. Paper: the value of the 'attachment' property. It's a step: it runs when the white wire reaches it, then the flow carries on from its Then pin. Find it under World & blocks in the palette.
When to use it
Use it when the flow needs to: changes the bell block's attachment to one of the attachment values you pick. Paper: the value of the 'attachment' property.
When not to
If nothing should change in Discord, a value node or a check is lighter.
Typical wiring
Sockets: settings you can wire
- Block Location
-
Where the bell block is: wire a location in, like Location from When a player breaks a block, or type world x y z.
What goes there: Type it in the side panel, or wire in a location. e.g. world 10.5 64 -3.2
If it's empty: Optional. Left empty and unwired, the step runs without it.