Entities & mobs · Step
Set dolphin moistness
Changes the dolphin's moistness to a whole number you pick. Paper: the moistness of this dolphin, once this is less than 0 the dolphin will start to take damage.
m.mob.dolphin.set_moistness
In a flow
“When a player right-clicks an entity → Set dolphin moistness: 1 → Answer Done!”
When a player right-clicks an entity → Set dolphin moistness: 1 → Answer Done!
What it does
Changes the dolphin's moistness to a whole number you pick. Paper: the moistness of this dolphin, once this is less than 0 the dolphin will start to take damage. It's a step: it runs when the white wire reaches it, then the flow carries on from its Then pin. Find it under Entities & mobs in the palette.
When to use it
Use it when the flow needs to: changes the dolphin's moistness to a whole number you pick. Paper: the moistness of this dolphin, once this is less than 0 the dolphin will start to take damage.
When not to
If nothing should change in Discord, a value node or a check is lighter.
Typical wiring
Sockets: settings you can wire
- Entity Entity
-
The dolphin: wire one in, like Entity from Spawn an entity.
What goes there: Type it in the side panel, or wire in an entity. e.g. Zombie
If it's empty: Optional. Left empty and unwired, the step runs without it.
- Moistness Number
-
The dolphin's new moistness.
What goes there: Type it in the side panel, or wire in a number. e.g. 42
If it's empty: Optional. Left empty and unwired, it uses 0.
Connects fromA member's variablesAccept applicationActive membersAddAdd a forum tagAdd a labelAdd a row to a Google SheetAdd a staff noteand 501 more