World & blocks · Step
Set the world spawn
Move a world's spawn point, where new players and the bedless appear.
m.world.set_spawn
In a flow
“When a player uses a command → If Is an operator → Set the world spawn at Player location.”
When a player uses a command → If Is an operator → Set the world spawn at Player location.
What it does
Move a world's spawn point, where new players and the bedless appear. It's a step: it runs when the white wire reaches it, then the flow carries on from its Then pin. Find it under World & blocks in the palette.
When to use it
Use it when the flow needs to: move a world's spawn point, where new players and the bedless appear.
When not to
If nothing should change in Discord, a value node or a check is lighter.
Typical wiring
Sockets: settings you can wire
- Where Location
-
The world's new spawn point: wire a location in, like Player location, or type world x y z.
What goes there: Type it in the side panel, or wire in a location. e.g. world 10.5 64 -3.2
If it's empty: Optional. Left empty and unwired, the step runs without it.